DRK-1070 Resistance Dry State Penetration Experiment

1 Product introduction:

The test system consists of a gas source generation system, a detection main body, a protection system, a control system, etc. It is used to conduct a dry microorganism penetration test method for surgical drapes, surgical gowns and clean clothes for patients, medical staff and instruments.

2 Features:

●Negative pressure experiment system, equipped with fan exhaust system and efficient air inlet and outlet filters to ensure the safety of operators;

●Industrial high-brightness color touch display screen;

● Large-capacity data storage to save historical experimental data;

●U disk export historical data;

●High brightness lighting inside the cabinet;

●Built-in leakage protection switch to protect the safety of operators;

●The inner layer of stainless steel in the cabinet is integrally processed and formed, the outer layer is sprayed with cold-rolled plates, and the inner and outer layers are insulated and flame retardant.

3 Matters needing attention:

In order to prevent damage to your dry-resistance penetration experiment system, please read the following safety instructions carefully before using this equipment, and keep this manual so that all product users can refer to it at any time.

① The operating environment of the experimental instrument should be well ventilated, dry, free of dust and strong electromagnetic interference.

② If the instrument works continuously for 24 hours, it should be powered off for more than 10 minutes to keep the instrument in good working condition.

③ Poor contact or disconnection may occur after long-term use of the power supply. Before each use, it should be repaired to ensure that the power cord is not damaged, cracked, or open.

④ Please use soft cloth and neutral detergent to clean the instrument. Before cleaning, make sure to disconnect the power first. Do not use thinner or benzene and other volatile substances to clean the instrument, otherwise it will damage the color of the instrument case itself, wipe off the logo on the case, and make the touch screen blurry.

⑤ Please do not disassemble this product by yourself, please contact our after-sales service in time if you encounter any trouble.

4 Overall structure and corresponding description:

The front structure diagram of the host of the dry microorganism penetration test system is shown in the following figure:

1: Touch screen

2: Master switch

3: USB interface

 4: Door handle

 5: Temperature sensor inside the cabinet  

 6: Pressure detection port

7: Air inlet port

 8: Detection body

9: Carrying handl